SigmaGate - Troubleshooting
- Quick access to troubleshooting guides below. Click here for all available information.
- 00. Check the main PCB, any LED diodes that is/isn't active
- 01. Check that there is power to the gate
- 02. Check that the motor key switch is turned on
- 03. If the gates are equipped with Mechanical Panic Breakout, check that the gates are manually returned to its zero position (locked position)
- 04. Check if the gates are being held open on the remote controls. Check that CLEANING MODE is not activated by checking for the illuminated Cleaning LED on the main PCB
- 05. Check connections of GateCOM cross-over cable by checking for the illuminated Saloon LED on the main PCB
- 06. Check that all 4 PEC sensors are aligned and centered on reflector using the indicator lights on each PEC sensor
- 07. Press the test button on Gatemaster board of the master gate
- 08. Press the test button on the main PCB on each gate
- 09. Bypass Entrapment board
- 10. Check the dipswitch settings
- 11. Check coulisse pcb / coulisse cables
- 12. Check cable chain assembly
- 13. Check the potentiometer settings
- 14. Check the Gatemaster board, any LED diodes that is/isn't active