If you're unsure which remote is the master remote or if you're adding additional remote controls to an existing relay, you'll need to erase the receiver's memory first. Follow the instructions below.
How to Erase the receiver memory
Note: Doing this will reset everything you have programmed and you will have to start over again with the pairing process.
- Power On the Receiver: Ensure the receiver is powered up.
- Enter Erase Mode:
- Place a jumper bridging J2 and the common (middle) pin.
- Confirm Erase Operation:
- The LED will flash 10 times, indicating the start of the erase procedure.
- Remove the J2 jumper after the flashes to complete the erase operation.
- Once the erase operation completes, the LED will switch off, and the receiver will return to normal operation.