Make sure the two photoelectric cells (PEC) are pointing at the reflectors on the other gate.

Adjust by using 2.5mm Allen keys through holes next to PEC sensor on the outside of gate.

1. Turn Allen key all the way LEFT until yellow connection light turns off.
2. Turn Allen key all the way RIGHT until yellow connection light turns off, counting the amount of turns in-between
3. Wind Allen key back to mid position.

Important Notes:

• If it takes 6 full turns from left position to right position, then turn back 3 full turns.
• This must be done to both vertical and horizontal directions.

If one PEC doesn't have contact with the reflective tape on the other gate, it will look like below:

No steady yellow light on the PEC.

Function OPEN NEXT/SCO CLOSE will be active on the main PCB.

Follow above steps to make it a steady yellow light:

Additional video

Recommended spare part

- If the PEC itself is faulty, below spare part can be ordered

.