Use GateMaster board to test the full functionality of the gates.

- Press red test button on gate master board (in master gate)

If test button triggers both gates to operate as per normal this would indicate that the fault is either IT related or with the data cable from the GateMaster board back to the comms cabinet.

Use the test button on the ScanMaster to trigger the gate. This will send an open gate signal to help check the timing of the gate. Please note that this will only trigger the gate and start the Secure timer until the PEC sensor is broken.

Hint: Use your hand to break the PEC beam to start the DELAY timer.

Additional video

Recommended spare part

- If the Gatemaster board and/or the SD-card itself are faulty, below spare part can be ordered.